MIS is a kind of fault action staff during operation because of carelessness caused by this action, not only will cause the equipment to the normal operation, may also cause severe short circuit, so the request is very high on the anti misplugging aspects. According to the introduction of Jun RJ45 connector line to line connector misplug proof of a total of two, were as follows:

On the one hand, on the line to the line RJ45 connector itself, rotate one hundred and eighty degrees, if the fault dislocation solution caused the signal connection makes a mistake, then it needs to pay attention as much as possible the selection of preventing wire to wire connectors, so to prevent this fault, together can prevent equipment damage, can also connect to the relative the configuration of the line range only by adjusting the line.

On the other hand, when the manufacturers choose the same connector, it is likely to be A plug into the B socket, this situation needs special attention, because once this situation, the results will be very serious, it is necessary to connect the AB interface is not the same as the socket.

And the use of line on line RJ45 connector to prevent this situation in a certain extent, so it is recommended to cut the material variety, or save the cost of the factory, in the use of process, must choose a reliable and safe line of line connector products, so as to allow the device to get excellent maintenance.

On the role of anti misplug line to the line of the RJ45 connector, though not completely, but with the development of science and technology and product updates, trust has very good treatment in the future.